Pushrod clearance
Moderator: Team
Pushrod clearance
What would be the minimum clearance the pushrod could have as it passed through the cylinder head near the intake ports. This is a SBC with 23 degree heads, and 3/8 pushrods.
A bad day of racing is better than a good day of work
-
- Member
- Posts: 84
- Joined: Tue Dec 28, 2004 7:13 pm
- Location:
They are Trickflow pushrods from Summit and have a .080 wall thickness.ALKYBURNER wrote:Look at Mantons website his catalog says .010 pushrod to any object port etc. is plunty it acts like a guide he told me. What wall thickness are they, I have had good luck with IRC performance pushrods out of Washington state.
Thanks for helping guys.
A bad day of racing is better than a good day of work