please help
Moderator: Team
-
- New Member
- Posts: 20
- Joined: Mon Jun 14, 2004 9:34 pm
- Location:
- Contact:
please help
I post a question on welding a cast Iron head only had one reply on someone that can do it surely there is got to be more people out there. I don't mind shipping it. This a well ported sporstman 2 head with great flow number and would like to get it fixed.
-
- Guru
- Posts: 2650
- Joined: Sun Sep 05, 2004 6:38 pm
- Location: salt lake city, ut
- Contact:
-
- New Member
- Posts: 20
- Joined: Mon Jun 14, 2004 9:34 pm
- Location:
- Contact:
-
- Guru
- Posts: 2650
- Joined: Sun Sep 05, 2004 6:38 pm
- Location: salt lake city, ut
- Contact:
-I read about the problem the first time and I know about the mess.
-But until I can see what and where and just how bad it is I can't get any sort of an idea as to what it'll take.
-I have virtually brazed 1/4" of a chamber back onto a similar Dart cast (high dollar head) iron head years ago and I sold that pair of heads to a friend in GA and he'd been running on a dirt track, put 4000 laps on the heads with NO problems.
-That head was broken right thru a sparkplug hole one head bolt hole into the exhaust shroud over and thru the dowel pin hole at out the rear.
-It had been on a blown SBC where they had reciever grooves in the head and torched past a gasket and about 3 inches around that groove right there by dowel pin and then the crack virtually broke that entire corner off but for about half an inch that was left to hold the chunk in place.
-So I need to see what it looks like.
-But until I can see what and where and just how bad it is I can't get any sort of an idea as to what it'll take.
-I have virtually brazed 1/4" of a chamber back onto a similar Dart cast (high dollar head) iron head years ago and I sold that pair of heads to a friend in GA and he'd been running on a dirt track, put 4000 laps on the heads with NO problems.
-That head was broken right thru a sparkplug hole one head bolt hole into the exhaust shroud over and thru the dowel pin hole at out the rear.
-It had been on a blown SBC where they had reciever grooves in the head and torched past a gasket and about 3 inches around that groove right there by dowel pin and then the crack virtually broke that entire corner off but for about half an inch that was left to hold the chunk in place.
-So I need to see what it looks like.
-
- New Member
- Posts: 20
- Joined: Mon Jun 14, 2004 9:34 pm
- Location:
- Contact:
-
- Guru
- Posts: 2650
- Joined: Sun Sep 05, 2004 6:38 pm
- Location: salt lake city, ut
- Contact: