Can anyone tell me the intake rocker stud angle WRT either the head or the intake valve stem?
Thanks.
BBC stud-mount rocker arm
Moderator: Team
-
- Guru
- Posts: 2650
- Joined: Sun Sep 05, 2004 6:38 pm
- Location: salt lake city, ut
- Contact:
Re: BBC stud-mount rocker arm
-I have a piece of a cut up Dart 320 head with #3 and #1 intake ports ---but only have the stud boss for #3 intake to measure.
-set the head on my mill table that is relatively level and got these numbers from the rocker stud pad.
-12.5 degrees tilted towards intake manifold from deck surface--and 4.5 degrees lower tilted downwards at the rear (tilted upwards on the divider wall side of the pad)
-set the head on my mill table that is relatively level and got these numbers from the rocker stud pad.
-12.5 degrees tilted towards intake manifold from deck surface--and 4.5 degrees lower tilted downwards at the rear (tilted upwards on the divider wall side of the pad)