Does anyone ELSE have a pair of mopar 340 "J" heads ?

General engine tech -- Drag Racing to Circle Track

Moderator: Team

Old as Dirt
HotPass
HotPass
Posts: 306
Joined: Thu Oct 08, 2009 12:09 pm
Location: Monroe Washington

Re: Does anyone ELSE have a pair of mopar 340 "J" heads ?

Post by Old as Dirt »

Warp Speed wrote: Tue Dec 12, 2017 6:46 pm
Old as Dirt wrote: Tue Dec 12, 2017 5:49 pm Probably up the Snohomish river Valley.. NE of Seattle..
Snoqualmie Valley actually, about 5 miles southeast of where the two meet! Lol
Ha Ha, less than ten minutes from the house.. Mucho Hillbillies w/ big guns... and a few Pothead Hippies too.. Duvall, somewhere up the Cherry Valley road.. you must be from these parts to be able to describe so well.. :mrgreen:
This Old Man would hang out with you if you are ever up this way.. got a 16' hotrod ski boat with a 347 SBF Stroker.. can you slalom, or are you too old? :twisted:
Warp Speed
Guru
Guru
Posts: 3285
Joined: Wed Jun 25, 2008 1:46 pm
Location: NC

Re: Does anyone ELSE have a pair of mopar 340 "J" heads ?

Post by Warp Speed »

Old as Dirt wrote: Tue Dec 12, 2017 8:38 pm
Warp Speed wrote: Tue Dec 12, 2017 6:46 pm
Old as Dirt wrote: Tue Dec 12, 2017 5:49 pm Probably up the Snohomish river Valley.. NE of Seattle..
Snoqualmie Valley actually, about 5 miles southeast of where the two meet! Lol
Ha Ha, less than ten minutes from the house.. Mucho Hillbillies w/ big guns... and a few Pothead Hippies too.. Duvall, somewhere up the Cherry Valley road.. you must be from these parts to be able to describe so well.. :mrgreen:
This Old Man would hang out with you if you are ever up this way.. got a 16' hotrod ski boat with a 347 SBF Stroker.. can you slalom, or are you too old? :twisted:
Grew up on Big Rock rd. You know the place! Hahaha
Keith Morganstein
Guru
Guru
Posts: 5566
Joined: Sun Feb 19, 2006 10:19 am
Location: MA

Re: Does anyone ELSE have a pair of mopar 340 "J" heads ?

Post by Keith Morganstein »

The heads were thick with crud. Once I ran them through the jet-wash, what looked like a "J". Turned out to be a "U"
image.jpg
You do not have the required permissions to view the files attached to this post.
Automotive Machining, cylinder head rebuilding, engine building. Can't seem to quit #-o
Post Reply