Pulling hard to right on launch

Shocks, Springs, Brakes, Frame, Body Work, etc

Moderator: Team

Posts: 86
Joined: Thu Mar 26, 2009 2:31 pm
Location: Madison, GA. [Atlanta area]

Re: Pulling hard to right on launch

Post by Geezer » Wed Nov 11, 2015 8:21 pm

'The old tired driver side one rolled crooked when. U rolled it on the floor
Inside of tire is feathered bad. Outside has a wavey. Pattern on it"
When you do the alignment, check the rearend for toe in/out.
Chuck L.
Hotrodding since 1955.
Injector Inspector.
Turbo Buicks in the 9's...

Posts: 194
Joined: Thu Oct 17, 2013 10:00 am
Location: Houston, Texas

Re: Pulling hard to right on launch

Post by Seanh832 » Mon Jun 27, 2016 7:34 am

I had tire slipping on the rim that caused hard right turn at launch. When my wheels were new i had them clear powder coated. Long story short the the coating on the bead was de-laminating causing the tire slippage. Got it all off on both wheels and had the slicks dry mounted. No more issues. I never run less than 10lbs tire pressure also.
Maintenance Machinist for Anheuser-Busch

Post Reply