Page 1 of 1

JE Pistons Interview

Posted: Thu Feb 05, 2004 1:01 am
by speedtalk
JE Pistons http://www.jepistons.com/ has just agreed to be on the show - really looking forward to this one. I think I've got some good questions, but if you've got any ideas, post them below.

Posted: Sun Feb 08, 2004 2:01 pm
by learner
BTW, i don't no if you noticed by i thanked you for the cd in the announcements forum. I have some questions for JE.

1- additional clearances for skirt coatings
2- besides material and application, what influences minimum skirt clearances, ie. skirt taper, size of oil ring drains etc.
3- they use two materials to my knowledge, 2618 and 4032. What is the maximum power limits for each?

Thanks

Posted: Sun Feb 08, 2004 2:17 pm
by speedtalk
I appreciate the thank you. Did you submit an order for the free cd yet? I want to make sure you get it.

Thanks for the questions, I'll add them to my list.

Posted: Sun Feb 08, 2004 2:34 pm
by learner
Yes, just a few minutes ago. I also ordered two others.
Thanks again.

Posted: Wed Mar 17, 2004 11:52 am
by speedtalk
Have any more questions? The interview is tonight at 8pm eastern

John Noonan, Jeff Ginter & Tony Ramos at JE Pistons

Posted: Wed Mar 24, 2004 5:54 pm
by speedtalk
Just finished editing the interview with John Noonan, Jeff Ginter & Tony Ramos of JE Pistons - it was a lot of fun.

Posted: Thu Jul 08, 2004 10:28 pm
by speedtalk
Lots of questions lately about pistons and rings so I thought I'd run this two part interview again. Enjoy
http://speedtalk.com/broadcast/index.html