Page 1 of 1

Keith Wilson - Wilson Manifolds

Posted: Fri Mar 05, 2004 5:23 pm
by speedtalk
Keith Wilson http://www.wilsonmanifolds.com has agreed to be on the show. If you have any questions you'd like me to ask during the interview, please post them below.

question for Keith Wilson

Posted: Sun Aug 08, 2004 8:02 am
by quickd100
I've looked at some of your manifolds and they are works of art. I took a stab at building a sheetmetal intake for my Hemi, (single 4 dominator tunnel ram). So far I haven't finished the motor to try it yet.
My question is; Is there a set in concrete formula you use for determining plenum volume when you construct a manifold? What factors do you use to deterine it's size?
Oh, I now know why you charge what you do for one. There was more hours of thought and fabrication involved in mine than I care to count. Dave

Posted: Sun Aug 08, 2004 4:46 pm
by speedtalk
Thanks Dave, I'll ask your question.

Posted: Thu Aug 19, 2004 4:41 am
by JACB
I would be interested in hearing about his work on the FAST LSX manifold. Did he just fine tune it or design it from scratch? What input did "Managed-Programs" have and who was the driving force in the project?

Posted: Thu Aug 19, 2004 9:00 pm
by speedtalk
Hello JACB, thanks for joining the forum. I'll add your questions to the list.

Posted: Tue Aug 24, 2004 11:02 pm
by RyanJ
Could you please talk a bit about surface finish, and your thoughts on runner divider shape/size in an intake manifold.... specifically cast aluminum single 4 intake manifolds. Thanks....