Page 1 of 1
Steve Bown - PSI Valve Springs
Posted: Thu May 13, 2004 10:13 pm
Steve Bown has agreed to come on the show. Questions for Steve can be posted below.
Posted: Mon May 17, 2004 5:21 pm
When is the interview?
I want to put together a list of questions.
Posted: Tue May 18, 2004 12:33 am
I'd say a week or so. Thanks for your input Bob.
Posted: Thu May 27, 2004 4:27 pm
2) If you have a spring that is the correct rate but it has an OD that is smaller than the spring pocket are locators necessary? What do you suggest?
3) How do you determine the fuss points or surge frequency points?
4) How do we obtain the premium springs (which generally have very high pressures and rates) for profiles requiring less pressure? For example, in a marine application for a BBC I may have a hyd roller cam 236*/242*@.050 and .610/.620 lift. Not a radical cam. Only requires 140# seat and 340# open, but I will run it for say 45 min at 5000 RPM. I need a bulletproof endurance spring but the competition parts don’t usually come at those rates. What are the alternatives? Special orders? What is a minimun run for a special order diameter/rate
5) What can be done to increase fatigue resistance? Coating/polish?
Posted: Thu May 27, 2004 9:09 pm
Posted: Thu Jun 03, 2004 10:26 am
Interview is scheduled for next Tue.
Posted: Mon Jun 07, 2004 10:45 pm
Can anyone order dirrect from PSI and whats the minimum order for a custom spring ?
What are the best quality materials for springs that don't loose pressure?
Posted: Mon Jun 07, 2004 11:55 pm
Thanks Tom, I'll add them to the list.
Posted: Tue Jun 08, 2004 4:50 pm
Interview went well today. I think I got everyone's questions asked. It will broadcast on 6/25
Posted: Fri Jun 25, 2004 2:52 pm
Has the Steve Brown/PSI interview been rescheduled?
Posted: Fri Jun 25, 2004 4:04 pm
My screw up. I'll run it on 7/2. Sorry about that.
Posted: Fri Jun 25, 2004 8:38 pm
speedtalk wrote:My screw up. I'll run it on 7/2. Sorry about that.
I'll let it ride this time Don