Hi,
Does anyone know how to remove the bearing assembly that is at the top of the mill where the draw bar goes through? It appears to me that you need a spanner wrench to loosen a outer race? Any ideas are greatly appreciated.
Thanks, Jay
Bridgeport repair ?
Moderator: Team
-
- Member
- Posts: 121
- Joined: Sun Feb 18, 2007 10:38 pm
- Location: Plainfield, IA
- Contact:
Bridgeport repair ?
Roeder Performance Machine
Stuska TrackMaster Gold LC engine dyno
Millport Super Red Rhino 5-axis machining center
5 -axis Simultaneous CNC Head Porting
http://www.roederperformancemachine.com
http://www.dragracingonline.com "Project Muscrate"
Stuska TrackMaster Gold LC engine dyno
Millport Super Red Rhino 5-axis machining center
5 -axis Simultaneous CNC Head Porting
http://www.roederperformancemachine.com
http://www.dragracingonline.com "Project Muscrate"
-
- Member
- Posts: 121
- Joined: Sun Feb 18, 2007 10:38 pm
- Location: Plainfield, IA
- Contact:
Thanks
I got it done today. Was actually pretty simple. Unscrew the two lock nuts and the bearings are a slip fit. They were definately shot! Runs much quieter now!
Jay
Jay
Roeder Performance Machine
Stuska TrackMaster Gold LC engine dyno
Millport Super Red Rhino 5-axis machining center
5 -axis Simultaneous CNC Head Porting
http://www.roederperformancemachine.com
http://www.dragracingonline.com "Project Muscrate"
Stuska TrackMaster Gold LC engine dyno
Millport Super Red Rhino 5-axis machining center
5 -axis Simultaneous CNC Head Porting
http://www.roederperformancemachine.com
http://www.dragracingonline.com "Project Muscrate"