Diamond platers

Tech questions that don't fit above forums

Moderator: Team

Post Reply
Big Jay
Member
Member
Posts: 86
Joined: Tue Aug 24, 2010 12:38 am
Location: Willow Springs Raceway
Contact:

Diamond platers

Post by Big Jay » Tue Dec 21, 2010 1:57 pm

Anyone know of a company that can replate the too sharpening wheel for a Kwick Way boring bar. They get way too much for a new one. Replating the wheel with new diamond should only run about $50.00

At one of the shows a few years ago, there was a company with a booth that does this. Anyone had it done?

Jay

Kevin Johnson
Guru
Guru
Posts: 7035
Joined: Tue Nov 22, 2005 5:41 am

Re: Diamond platers

Post by Kevin Johnson » Thu Dec 23, 2010 7:39 am

http://www.trinitydiamond.com/products.html

Worth a call -- they say they do it.

donc
Guru
Guru
Posts: 1188
Joined: Sat Dec 04, 2010 9:10 am

Re: Diamond platers

Post by donc » Thu Dec 23, 2010 8:44 am

you can recharge the lap yourself if you care to. purchase the diamond dust ( thats what we used to call the stuff ) spread the dust as evenly as you can on the lap then use a hard piece of steel preferably tool steel on top of lap put it in a press . press it together the material of the lap is soft enough to absorb the dust.

Post Reply