Anyone know of a company that can replate the too sharpening wheel for a Kwick Way boring bar. They get way too much for a new one. Replating the wheel with new diamond should only run about $50.00
At one of the shows a few years ago, there was a company with a booth that does this. Anyone had it done?
Jay
Diamond platers
Moderator: Team
-
- HotPass
- Posts: 9398
- Joined: Tue Nov 22, 2005 5:41 am
- Location:
Re: Diamond platers
https://www.semasan.com/breaking-news-archives?utm_campaign=DrivingForce_DF272&utm_content=SeeAllLeg
Re: Diamond platers
you can recharge the lap yourself if you care to. purchase the diamond dust ( thats what we used to call the stuff ) spread the dust as evenly as you can on the lap then use a hard piece of steel preferably tool steel on top of lap put it in a press . press it together the material of the lap is soft enough to absorb the dust.