AN Fittings Size
Posted: Mon Jun 27, 2011 10:15 pm
What is the proper size ID suspose to be on AN 6 fittings?
I bought some AN 6 45 female ends to day (several) and the tubing up inside is smaller diameter than some AN 6 fittings I had on my fuel lines. 7/32 drill bit size in the hole. Why are some smaller than others and what brands are the correct ID for the tubing? I would think this could be a choke for carb inlets. Plan to use them on my trans cooler but disappointed in the flow orfice.
I bought some AN 6 45 female ends to day (several) and the tubing up inside is smaller diameter than some AN 6 fittings I had on my fuel lines. 7/32 drill bit size in the hole. Why are some smaller than others and what brands are the correct ID for the tubing? I would think this could be a choke for carb inlets. Plan to use them on my trans cooler but disappointed in the flow orfice.