NOT ALLOWED: Selling or reselling in a retail manner.
4 posts • Page 1 of 1
- Posts: 505
- Joined: Mon Aug 10, 2009 10:11 pm
- Location: OHIO
I have a Red 530 for sale. I am the 2nd owner. Have had it since 1994. In my old shop used it to mill/angle mill heads. Have not used it in new shop/only placed it and wired it. That was in 1999.[its been covered] I now need the room for some new equpt. It is the 3 speed model. Has Bolster Plate set-up and Over Arm set-up with all the wedge plates and points. Still has the machining pattern from Van Norman in the bed top. Runs on 220 single[actually std oven-dryer 2 phace] power that every shop/house has. Machine is under power until end of the month/April-2010.The machine is clean and in good condition. Yes the cutters should be touched-up, but dont they all. My price is 1800.00 loaded on your trailer-truck/ Will also put on pallet/skid for truck shipping and take it to terminal[local] for addl 100.00. Any takers??? Its going into storage after 5/1/10. I also have the book for it and some misc pcs that we made that go with it. If 1800.00 is TOO much for you, then make a reasonable offer. I prefer to sell it to someone over 100 miles from me, that way I dont have to compete with it for work. Please PM me here it you are interested and I will reply. I am old[60+] and dont know how to post pics.so dont ask. It is a good/clean machine [unlike the ones I have seen on E-Bay for 2500.00 and up]. You wont waste a trip to come and look-take it with you. Machine is located in north cental Ohio-on lake Erie.
Some people are so stupid that they dont even know it! - by a famous Hillbilly