Looking for a line-boring jig for a model A ford

[YOJIMI]

Hello,
I have a line-bore machine , but need the jig used to align the boring bar in newly poured babbitt in the mains in Model A and B Fords, the machine that I have is a Serv-Equip {looks like a van-norman LB3200} I think the alignment jigs from a Tobin-Arp machine will work .These jigs fit into the cam bearing hole and rest on the oil pan rail, leaving a hole to place the boring bar in , or to indicate off of
thanks for looking
JIMI

[PackardV8]

I don't have the jig you need, but I do know maybe the best Model T/A machinist in the country. He does them every week and can point you toward what you need. Call Rick @ Strong Engine (509) 891-6461. Tell him Jack sent you.

jack vines

[meskhov]

Hello
I have the jigs you need. They are brand new tobin arp and fit A and B.
$800 plus shipping.
Mike
(508)460-0733
Thanks
Ps I also have the fordson tractor ones as well.

[leahymtsps]

Hello,
I have a line-bore machine , but need the jig used to align the boring bar in newly poured babbitt in the mains in Model A and B Fords, the machine that I have is a Serv-Equip {looks like a van-norman LB3200} I think the alignment jigs from a Tobin-Arp machine will work .These jigs fit into the cam bearing hole and rest on the oil pan rail, leaving a hole to place the boring bar in , or to indicate off of
thanks for looking
JIMI

There is a pair listed on ebay

Tom