I am looking for a used Torque/Honing plate for a Buick 3.8.
Bore would be 3.8"+, with a bore spacing of about 4.250. Bolts would be about 4.250 x 3.100. Dimensions measured with my caliper.
NOT ALLOWED: Selling or reselling in a retail manner.
2 posts • Page 1 of 1
- New Member
- Posts: 14
- Joined: Fri May 31, 2013 6:16 pm
I have a plate for the 3.8 Buick engine that we built awhile ago. We don't use it anymore, it's steel and 1.5 inches thick with a cylinder bore of about 4.00. I'd sell this for $75.00 plus shipping. I am located in Rochester, MN.