Page 1 of 1
WTB: Crank grinder
Posted: Wed Mar 09, 2016 4:33 pm
by bubbabbc
Wanted: AMC-Schou 1100 to 1500 crankshaft grinder. Must be in good condition, I do not want to rebuild the machine. Berco 225 would also be a consideration. Call Mike @ (315) 695-2454 Thanks
Re: WTB: Crank grinder
Posted: Wed Mar 09, 2016 5:59 pm
by PackardV8
Would you have any interest in a Storm-Vulcan Model 15 if it were complete, working condition and less than $10,000?
Re: WTB: Crank grinder
Posted: Wed Mar 09, 2016 10:37 pm
by Alan Roehrich
Jack, whatcha got?
Re: WTB: Crank grinder
Posted: Thu Mar 10, 2016 11:54 am
by PackardV8
Storm Vulcan 15A on centers/y-drive
Arnold gauge
Stone dresser
Five loaded hubs and two new stones
Radius dresser
Two steady rests
Fully tooled and operational.
$9995 delivered to your door. Alan.
Re: WTB: Crank grinder
Posted: Wed Mar 23, 2016 6:27 am
by Adger Smith
I have a nice set of Chucks that will fit Jacks machine and replace the Y drivers. I also have a rebuilt drive motor.
Re: WTB: Crank grinder
Posted: Wed Mar 23, 2016 11:05 am
by Cummins Machinest
Adger Smith wrote:I have a nice set of Chucks that will fit Jacks machine and replace the Y drivers. I also have a rebuilt drive motor.
how much?
Re: WTB: Crank grinder
Posted: Wed Mar 23, 2016 12:03 pm
by Adger Smith
The rewired 3 phase drive motor & the chucks $500.
Re: WTB: Crank grinder
Posted: Wed Mar 23, 2016 3:52 pm
by bubbabbc
The original post is all set, Mike found what he needs. But you guys can keep using the heading. Thanks
Skip