WTB CV616 feed control parts
Posted: Sat Nov 12, 2016 7:39 pm
Hey guys,
I am looking for the upper and lower feed pawls and the double eccentric for a CV-616 honing machine
Sunnen Part Numbers are as follows
CK255A upper feed pawl
CK-255A lower feed pawl
CK269A double eccentric
These are used to advance the feed of the stones while honing automatically so you don't have to hold the feed wheel and do it.
I have another machine I want to use for small honing jobs and need these to get it up and running again.
Any suggestions/ leads welcome
Thanks for looking
Dave
I am looking for the upper and lower feed pawls and the double eccentric for a CV-616 honing machine
Sunnen Part Numbers are as follows
CK255A upper feed pawl
CK-255A lower feed pawl
CK269A double eccentric
These are used to advance the feed of the stones while honing automatically so you don't have to hold the feed wheel and do it.
I have another machine I want to use for small honing jobs and need these to get it up and running again.
Any suggestions/ leads welcome
Thanks for looking
Dave