Don Terrill’s Speed-Talk

This is an older Kwik-Way SV valve grinder that is being offered. This is not to be confused with an antique & collectable. This is a highly accurate productive and reliable tool. I use this for racing and high performance work and can hold <.0005 TIR on the valve seat face and is repeatable.

Upgrades are as follows:
Accu-Chuck, ER32 chucking system with 4 sizes collets
Dial indicator and mag base
Coolant pump, little giant, 300 gph
Coolant change valves and piping
Rewiring with proper grounding
LED Lighting
Stellite grinding wheel
Coolant system replumbing with valves and adjustable pipes

I have no apprehension selling this machine and the only reason it goes is I have purchased a faster unit. The price is very fair considering the work this machine does. Crating $125 shipped prepaid common carrier.

I'll take it can you you please price shipping to Ireland , or what rough weight is it

Cheers

Hi

or Florida , i can get my parts supplyer to trow it in with an order

Cheers

Hi

just said i'd check whats the smallest valve size valve it takes

Cheers

I have cut 6mm valves with it just fine. I am sure with the right collet it would go smaller.

I would like to confirm this has been sold. If not, I am interested


Paul

Not as of yet
I patiently waited for a man to provide funds but at this point I must say it is available.

PM sent on Nov 18th. No reply. Do you want to sell?

All finally landed safe and sound thanks for being a gent through the hole ordeal, the shipping was some mess on this end when landed, top marks on your carpentry skills the create performed well considering its journey half way around the world,

Thanks again for all your assistance