are guys cutting 3 ange to valves & whats the cost
Posted: Sun Jul 02, 2017 6:12 pm
Hi
So I dropped of a set of heads and asked for the 3 angle valve job exhaust throats to be opened 1mm and back cut , said no problem he's got the newan bb. any way collected all , went to install the new springs valves stem seals and seats look good but he decided not to open up the exhaust , and only 45deg on the valves , no back cut either . what is the run of the mill pricing for doing the job correctly to finish it and cut all the relevant angles into the valves , say 16v heads or am i wrong and this is not normally cried out , I am aiming to do our own heads here in the future but what is the general cost and or is it really a nonprofit procedure [ pain in the ass ]
Cheers
So I dropped of a set of heads and asked for the 3 angle valve job exhaust throats to be opened 1mm and back cut , said no problem he's got the newan bb. any way collected all , went to install the new springs valves stem seals and seats look good but he decided not to open up the exhaust , and only 45deg on the valves , no back cut either . what is the run of the mill pricing for doing the job correctly to finish it and cut all the relevant angles into the valves , say 16v heads or am i wrong and this is not normally cried out , I am aiming to do our own heads here in the future but what is the general cost and or is it really a nonprofit procedure [ pain in the ass ]
Cheers