Keith Wilson - Wilson Manifolds
Moderator: Team
- speedtalk
- Site Admin
- Posts: 983
- Joined: Mon Apr 21, 2003 2:43 pm
- Location: Kalamazoo, MI
- Contact:
Keith Wilson - Wilson Manifolds
Keith Wilson http://www.wilsonmanifolds.com has agreed to be on the show. If you have any questions you'd like me to ask during the interview, please post them below.
Don Terrill
SpeedTalk Owner/Admin
SpeedTalk Owner/Admin
-
- Pro
- Posts: 307
- Joined: Sun Jul 18, 2004 7:34 am
- Location: Nielsville, Mn.
question for Keith Wilson
I've looked at some of your manifolds and they are works of art. I took a stab at building a sheetmetal intake for my Hemi, (single 4 dominator tunnel ram). So far I haven't finished the motor to try it yet.
My question is; Is there a set in concrete formula you use for determining plenum volume when you construct a manifold? What factors do you use to deterine it's size?
Oh, I now know why you charge what you do for one. There was more hours of thought and fabrication involved in mine than I care to count. Dave
My question is; Is there a set in concrete formula you use for determining plenum volume when you construct a manifold? What factors do you use to deterine it's size?
Oh, I now know why you charge what you do for one. There was more hours of thought and fabrication involved in mine than I care to count. Dave
[img]http://img.photobucket.com/albums/v514/quickd100/9ff3c690.jpg[/img]
- speedtalk
- Site Admin
- Posts: 983
- Joined: Mon Apr 21, 2003 2:43 pm
- Location: Kalamazoo, MI
- Contact:
- speedtalk
- Site Admin
- Posts: 983
- Joined: Mon Apr 21, 2003 2:43 pm
- Location: Kalamazoo, MI
- Contact:
-
- New Member
- Posts: 45
- Joined: Tue Aug 24, 2004 8:38 pm
- Location: State College, PA
- Contact: