General engine tech -- Drag Racing to Circle Track
- Posts: 696
- Joined: Sat Sep 24, 2005 10:52 am
the easiest way is to use an old valve. If you don;t have a valve. drop a bolt with a large head down the guide then a washer that loosely fits the seat id then 3 welds mig or stick are fine about 3/8-1/2 long to the seat and washer. then tap it out.
- Posts: 5135
- Joined: Mon Sep 17, 2012 3:19 pm
- Location: Elverson, PA
Thats how I do it....and I have a tig. I take an old valve and grind it to drop into the seat then mig weld mostly on the seat, a little on the valve then tap the valve to pop it out. Hit the seat with a hammer to get it and most of the weld off the valve, on to the next one.