Kwik Way FN bar

[ProPower engines]

Hi guys
I have a KW FN bar thats been sitting in the corner for years as the air center head was crashed 1 to many times byt I want to put it back into service.

I talked to the KW guy and hes asking $4000 for the parts. I called a couple years ago and was quoted about half that cost to do the same air to manual conversion.
Does anyone have a FN bar with manual centering for parts they are not using??

I get this stuff is hard to locate and the guy that bought the KW inventory is a little off his rocker.
When a decent used bar with no tool kit can be had at a reasonable cost.

If anyone has any suggestions where to look aside from surfing the net I would be eternally grateful

Dave

[Kingbee]

Have you talked to Stu at Jamison equipment or Kevin at Taylor equipment in Glenwood, Iowa?

[ProPower engines]

NEVER THOUGHT ABOUT kEVIN OR STU
I WILL GIVE THEM A CALL MONDAY